Why Leander water changes the routine
Our water arrives loaded with minerals, and a hot tub is basically a minerals concentrator. Every top-off adds more. Heat drives some of it out of solution as scale, which then settles on the heating element, in the jets and along the plumbing walls.
That's why the standard advice to drain on a rough schedule works better here when you actually follow it. A tub left too long accumulates dissolved solids until the water won't balance, no matter what you add. The only reset is a fresh fill.
Add the summer factor. A lot of Leander tubs are used heavily in cool months and neglected in July. Sanitizer burns off, algae and biofilm get started, and the plumbing becomes the hiding place. We deal with all of that during a cleaning.
What a service visit does not do
A cleaning is not a repair, and we keep the two separate. If we find a failing gasket, a worn filter or a pump that sounds tired, we point it out and explain what it means. Any repair is its own conversation, and nothing happens without your approval.
We also don't hand you a rigid calendar. Some tubs are used every night and need attention often. Others are used a few times a month. We'll suggest a rhythm based on how your tub is actually used, and you can adjust it as the seasons change.
What to do before we arrive
- Tell us roughly when the tub was last drained and how it's been used.
- Take the filters out only if you know how; otherwise leave them for us.
- Make sure we have a garden hose spigot we can use for refilling.
- Decide where the old water should go. We'll drain to a spot that doesn't flood a neighbor or your own flower beds.
- Keep the cover accessible and clear the area around the tub.
- If the water smells or is cloudy, don't add more chemicals before we arrive.
Signs maintenance is overdue
Cloudy water
It stays hazy even after you shock it and run the filter.
Slimy or sour smell
Often a biofilm problem living inside the lines.
Scale on the waterline
A rough white or tan crust you can feel with your fingernail.
Foam that keeps returning
Oils and residue have built up past what balancing can fix.
Filters stay dirty
You rinse them and they clog again within days.
Chemicals aren't holding
Readings swing wildly after every adjustment.
What a cleaning covers
A proper service is more than a quick rinse. Here is what we work through.
- Drain the tub completely and clear the footwell and seat areas.
- Flush the plumbing with a line cleaner to loosen biofilm and residue.
- Scrub the shell and wipe down the waterline.
- Clean or soak the filters, and flag any that are worn out.
- Inspect the cover, headrests and visible fittings while the tub is empty.
- Refill, test and balance the water, then explain the readings.
Quick questions
How often should the water be changed?
Many tubs need a fresh fill roughly every three to four months. Heavy use, lots of bathers, or very hard fill water can mean sooner.
Do you also fix problems you find during a cleaning?
If we spot something worn, like a gasket or a filter past its life, we tell you and quote the repair separately. Nothing gets done without your say-so.
Can cleaning fix cloudy water?
Often yes, especially when buildup in the lines is the cause. If it keeps returning, we look for an equipment problem like weak circulation.